Hylands House - Entrance

After making most of the details of Hylands House it was starting to look very effective. I next needed to make the front roof the building by making a box and pulling two of the top edges together. I then used the chamfer tool to make the edges look 3D. This was then put on top of a box and the align tool was used to make sure that it fit on top of the box well.













This is the rendered image of the two shapes put together. I also applied the material to the shape and made sure the square is slightly bigger than the square on the bottom.















After putting the shapes together and putting them in place on the building I had to put the columns underneath them. The original columns look slightly different to the columns on the front of the building. For this I extended them in length and equally aligned them under the two shapes. I also put two other squares on the entrance underneath the columns.